System information

SECTION THREE - CONVERSATIONAL INPUT SCREENS
Mill START and END are not to be used with pocket routines.
Note: All milling auto routines must be activated with the tool at the center of the routine.
The conversational screen for pocket mill setup appears as follows.
Note: See pages 218, 225 in Section 4 and 316 in Section 5 for further information on pocket
routines.
F2 (Circ) Mill-Pockt-Circ
The F2 (Circ) selection brings up the following soft key selections.
F1 (Clear) Mill-Pockt-Circ-Clear
The conversational screen for CW circular pocket clear appears as follows.
Note: See page 218, Section 4 for further information on circular pocket clear.
143