System information

SECTION THREE - CONVERSATIONAL INPUT SCREENS
F5 (Polyg) Mill-Pockt-Polyg
The conversational screen for the polygon cycle appears below.
Note: see page 231 , Section 4 for further information on the polygon cycle.
F6 (Frame) Mill-Frame
The F6 (Frame) frame mill selection brings up the following soft keys.
F1 (Setup) Mill-Frame-Setup
The F1 (Setup) screen is used to set parameters necessary for circular and rectangular frame mill
routines. Setting parameters must be done prior to any frame milling routines.
Mill START and END are not to be used with frame routines.
Note: All milling autoroutines must be activated with the tool at the center of the routine.
The framing autoroutines can use the G65 X___Y___ to specify the center.
The conversational screen for frame mill setup appears as follows.
147