System information

SECTION THREE - CONVERSATIONAL INPUT SCREENS
The screen pictured above is the single position hole drill screen. One hole will be drilled or
tapped at (1,2). If a dimension is entered in the Z field on this screen it will drill the new depth at
(1,2) and subsequent holes. If the only dimension entered appears in the Z field, the Z axis will
move to that position; no hole will be drilled, and the Z depth will remain unchanged. This can
be useful for clearing clamps or fixtures.
The screen pictured above is the position drill screen using the grid holes option. It will drill a 6
x 5 grid of holes with 1" spacing in the X axis and .75" spacing in the Y axis. The first hole is at
(1,2). Below is a picture of the hole pattern created by this event.
164