System information

SECTION THREE - CONVERSATIONAL INPUT SCREENS
F3 (Misc) brings up the miscellaneous function screen and allows those functions to be
programmed during drill cycles. The F4 (Call) screen allows subprograms to be called during a
drill cycle. These subprograms would normally contain the drilling positions for different drilling
operations.
Note: See page 177, Section 3 for more information on miscellaneous.
See page 178, Section 3 for more information on call.
F5 (End)
Below is the conversational screen for disable canned cycle.
This screen does not require any entries but must be stored in the program to terminate the active
drill cycle. If this screen is not stored, every move will cause a Z axis drill cycle to be performed.
Sample Drilling Program
Event 0 of 17
Program Setup
Program name [Sample drilling program]
166