System information

SECTION TWO - FRONT PANEL OPERATION
Diagram of Main Screen
1 RunTime
When you are verifying a program the runtime displays the calculated time to make the
parts. When you are running a program it shows the elapsed time since the program was
started. The total of all program run times are kept in the “Job Time” parameter (F7 Parms
– F9 Ctrl).
2 History Line
History Line shows you where you are in the software and where you came from. If you
are modifying the tool table, the history line would say Main-Parms-Tool-Edit.
3 Active Program
Active Program displays the program that you are running or verifying. If you are editing a
program it will show the active edit program. If you are sending a file over the RS-232 it
will show the program being sent.
4 Current Position
Current Position is the position relative to the work offset zero.
5 Next Position
If you are running or verifying, the Next Position is the position that the machine is going
to.
6 Distance
Distance is the remaining distance the machine has left to go to finish the move being
executed.
7 The Function Keys
Highlighted Function Keys are active or available.
8 Status Window
Status Window displays detailed information on the state of the control. A detailed
description is given below.
13