System information

SECTION FOUR - PREPARATORY FUNCTIONS (G CODES)
Note 3: G52 offsets are not affected by the position of the machine. G92 offsets
are
affected by the position of the machine.
Note 4: G52 offsets are zeroed on power-up, after homing, after setting work offset
in handwheel or jog, and after any G92 command.
Note 5: G52 offsets are restored to there initial values after the program ends.
G55
X2 Y2 moves to P3
G52 X1 Y1 sets zero at P2 dim. rel. P1
X1 Y1 stays at P3
X2 Y2 moves to P4
Using G92
X2 Y2 moves to P4
G55
X2 Y2 moves to P3
G92 X1 Y1 sets zero at P2 dim. rel. P3
X1 Y1 stays at P3
258