System information

SECTION FOUR - PREPARATORY FUNCTIONS (G CODES)
2. Feeds down to point V.
3. Counter bores the hole (to radius P150).
4. Feeds down by Q value or Z point (whichever is less).
5. Repeats steps 3-4 until point Z is reached.
6. Rapids to initial point / point R as determined by G98/G99.
Fine bore cycle (G76)
Note 1: The V command is optional. If left out, the 1
st
depth would equal R__ - Q__
Note 2: It is possible to do a conventional cut (clockwise) by using mirror image.
The distance and angle is specified by control parameters bore relief angle and bore relief
distance.
278