System information

SECTION FOUR - PREPARATORY FUNCTIONS (G CODES)
The G82 command is similar to the G81 command; however, a dwell (specified by the P
command) is performed at the bottom of the hole. This cycle will do the following.
1. Rapids to point R
2. Feeds down to point Z
3. Dwells by P___ seconds
4. Rapids to initial point/point R as determined by G98/G99
Peck drilling cycle (G83)
G83 G98/G99 Z___ R___ V___ Q___ D___ F___
The G83 command specifies the peck drill cycle. This cycle will do the following.
1. Rapids to point R
2. Feeds to Point V
3. Rapids up to point R
Note: The V command is optional; if left out, the first depth would equal R___ - Q___.
4. Rapids down to D value
5. Feeds down by Q value or Z point (whichever is less)
6. Repeats steps 3-5 until point Z is reached
7. Rapids to initial point/point R as determined by G98/G99
282