System information

SECTION FIVE - MISCELLANEOUS FUNCTIONS (M CODES)
Wall angles are described as follows, regardless of pockets or islands.
If you are using a ball-nosed tool with the tapered walls, use an M95 EO (or M95). If you are
using an end mill, use M95 E1.
Example Program:
This program makes a 2" x 3" cavity with 30° walls.
P140=.1 Clearance
P141=-1 Final Z depth
P143=.1 Z increment
P144=0 1st Z depth, top of cut
P160=P144
P162=0 To enter while loop
While P162 =0 Start of loop
G41 G65 X0 Y1 Cutter comp lead in
X0 Y0
G1 F10 Z [ P160 ] Z down
X2 Geometry
Y3 Geometry
X0 Geometry
Y0 Geometry
G65 X1 Y0 Lead out
P163=30 Wall angle
M95 Taper walls command
Wend End while loop
311