System information

SECTION FIVE - MISCELLANEOUS FUNCTIONS (M CODES)
Notes on Rounded Walls
Note 1: The first cut at the first Z depth is always offset the entire tool radius.
Note 2: The first Z depth should be at the top of the surface to cut.
Note 3: If the wall radius and start angle will not span the first Z depth and final Z depth,
an error will occur.
Start angles are defined and illustrated in the following drawings. Negative start angles are
allowed.
If you use an E0 or no E on the M95 (or M96) block, the control uses a ball nose on the wall.
Any other E# on the M95 (or M96) instructs the control you are using an end mill. The offset
round/tapered walls has no effect on the end mill option.
315