System information

SECTION SEVEN - SAMPLE PROGRAMS
EIA Program Sample 1
N1 G0 G17 G20 G32 G40 G50 G69 G80 G90
N3 X-1 Y-1 S3000 M03
N7 Y3.5
N2 T1 M6
N4 G43 H1 Z.1 M08
N5 G01 Z-.375 F5
N6 G41 D1 X0 F25
N8 X1.5
N9 G3 R1 AA180 AB-45
N10 G1 R.S AB45
N11 G2 R1 XC5.9142 YC4.0858 AB0
N12 G1 Y0
N13 X-1
N14 G40 Y-1
N15 G0 Z.1 M9
N16 M5
Explanation of EIA Program Sample 1
N1 Selects rapid, XY plane, inch, and Z to tool change position; cancels cutter compensation,
scaling, rotation, and canned cycles; selects absolute dimensioning. (All programs default
G17, G40, G50, G69, G80, and G90. G20 is modal.)
N5 Feeds Z-.375 at 5 ipm
N7 Line move to X0 Y3.5
N2 Tool change #1
N3 Positions to X-1 Y-1 and turns spindle on (3000 rpm)
N4 Calls tool #1's "H" offset, positions Z to .1, and turns on coolant
N6 Selects left cutter compensation, calls tool #1's "D" offset, and feeds to X0 Y-1 at 25 ipm
Note: The cutter compensation will ramp on during this move.
N8 Line move to X1.5 Y3.5
N9 CCW arc 1" radius starting at 180° , ending at -45°
N10 Line move using an estimated end point described using polar coordinates; angle 45°
radius .5
N11 CW arc 1" radius absolute center of XC5.9142 YC4.0858 and an end angle of 0°
348