System information

SECTION SEVEN - SAMPLE PROGRAMS
Explanation of EIA Program Sample 2A
N1 Tool change #1
N2 Rapid position to X-1 Y1; turns spindle on CW (3000 rpm)
N3 Calls tool #1's "H" offset and positions Z to .1; turns on coolant
N4 Feeds Z-.375 at 5 ipm
N5 Selects right cutter compensation, calls tool #1's "D" offset, and moves to X0 at
25 ipm.
Note: Cutter compensation will ramp on during this move.
N6 Line move to X0 Y-1.5
N7,N8 Are the X,Y center point of the first arc
N9 Radius of first arc
N10, N11 Are the X,Y center point of the second arc
N12 Radius of second arc
N13 Radius of tangent arc
N14 Tangent arc function
N15 First arc with end point
N16 Tangent arc with calculated center and end point
N17 CCW arc 1" radius using an XC4.4142 YC-1.5 and an end angle of 0°
N18 Line move to X5.4142 Y0
N19 Line move to X-1 Y0
N20 Turn off cutter compensation, move to X-1 Y1
Note: Cutter compensation will "ramp off" during this move.
N21 Rapid Z axis to .1, turns off coolant
N22 Turns off spindle
360