System information

SECTION SEVEN - SAMPLE PROGRAMS
N3 Sets a "point before pierce" of X0 Y99
N10 CW arc 1" radius using an XC-4 YC2 and an end point of X5 Y2
N11 CCW arc 2" radius using an XC7 YC2 and an end point of X9 Y2
N12 Line move to X9 Y5
N13 Line move to X0 Y5
N14 Line move to X0 Y0
N16 Turns off cutter compensation
N18 Turns off spindle
Note: Machine does not move to this position.
N4 Sets a "pierce point" of X0 Y0; moves to its compensated point as established by the
previous block
N5 Calls tool #1's "H" offset, positions Z to .1, and turns on coolant
N6 Feeds Z-.375 at 5 ipm
N7 Line move to X1 Y0 at 25 ipm
N8 CW arc 1" radius using an XC2 YC0 and an end angle of AB135
N9 Line move using an estimated end point and described polarly, angle 45 radius .5"
N15 Establishes a "point after pierce" of X99 Y0
Note: Machine does not move to this position.
N17 Rapids Z to .1, turns off coolant
366