System information

SECTION SEVEN - SAMPLE PROGRAMS
N4 Sets a "pierce point" of X0 Y0; moves to its compensated point as established by the
previous block
N5 Calls tool #1's "H" offset, positions Z to .1, and turns on coolant
N6 Feeds Z-.375 at 5 ipm
N7 Line move to X0 Y2 at 25 ipm
N8 CW arc 2" radius using an XC2 YC2, an estimated end angle of 45° degrees, and an end
option (round corner) of .0001" radius
Note: The end option of a .0001 radius forces an intersection between the arcs.
N9 CW arc 2" radius using an XC4.8284 YC2 and an end angle of 0 degrees
N10 Line move to X6.8284 Y0
N11 Line move to X0 Y0
N12 Establishes a point after retract of X0 Y99
Note: Machine does not move to this position.
N13 Turns off cutter compensation
N14 Rapids Z to .1, turns coolant off
N15 Turns spindle off
Conversational Program Sample 5
Event 0 of 9
Program Setup
Program name [SAMPLE 5 ]
Dimensions [Absolute]
Units [English]
Work Coordinate [---]
Setup Notes:
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
---------------------------------------------------
393