System information

SECTION SEVEN - SAMPLE PROGRAMS
N3 Establishes a "point before pierce" of X0 Y0
Note: Machine does not move to this position.
N4 Establishes a "pierce point" of X.5 Y1.5; moves to its compensated point as established
by the previous block
N5 Calls tool #1's "H" offset, positions Z to .1, and turns coolant on
N6 Feeds Z-.375 at 5 ipm
N7 Line move to X1 Y3 at 25 ipm
N8 Line move to an estimated end point of X0
N9 CCW arc 1.5" radius using an XC-1.2689 YC2.2 and an estimated end point of X-3
N10 Line move to X-4 Y3
N11 Line move to X-6.1 Y.5
N12 Line move to X-6.1 Y0
N13 Line move to X0 Y0
N14 Line move to X.5 Y1.5
N15 Establishes a "point after retract" of X1 Y3
Note: Machine does not move to this position.
N16 Turns cutter compensation off
N17 Rapids Z to .1
N18 Ends program, turns spindle and coolant off
398