System information

APPENDIX
100 Disk read error
An attempt was made to edit a file that has been corrupted in some way, perhaps
loss of power while editing, or an error 101 occurred while editing. Try a different
file to see if the problem is specific to one particular file. If this is the case, the
program must be recreated.
1) ENTER (C:/RAM should be displayed)
5) DEL O####(#### is your part number)
Note: This error occurs when trying to edit conversational files that were created
with SLS software.
101 Disk write error - Parts memory is full
To avoid this error, remove programs from memory when you are done using
them (store on a floppy). Also, watch the amount of memory available as you are
programming. Deleting some programs from the parts memory will free up space
for additional programs.
Procedure to recover from ERROR 101
(Disk write error: Parts memory full)
Type in commands that are shown in CAPITAL letters, followed by the ENT key.
2) CD.. (change directory)
3) CD PARTS (change to the parts directory)
4) DIR (list PART files)
NOTE: You can recreate your O#### file from your conversational (P####) file
by reposting it.
6) Power the machine OFF, then ON again, to RESET the control. Use UTIL-
FILES-ERASE to erase programs that are no longer needed.
NOTE: You can check how much parts memory is available by using UTIL-INFO to look at
the information page.
102 File not assigned
103 File not open
104 File not open for input
105 File not open for output
106 Invalid numeric format
406