System information

APPENDIX
150 Disk is write-protected
Check the write protect tab on the floppy disk that is being used.
151 Unknown unit
152 Drive not ready
Check to see that there is a disk in the floppy drive.
153 Unknown command
154 CRC error in data
The disk being read is corrupted.
155 Bad drive request structure length
156 Disk seek error
Check the cabling from the control to the floppy drive.
157 Unknown media type
158 Sector not found
159 Printer out of paper
160 Device write fault
161 Device read fault
162 Hardware failure
Improper format on the floppy disk. Try another disk or try reformatting the same
disk. Verify that floppy cables are properly connected.
163 Sharing Violation
200 Division by zero
201 Range check error
202 Stack overflow
203 Heap overflow - Insufficient RAM memory
Run the DOS command CHKDSK to determine the amount of RAM that is
available on the system. If possible, unload unnecessary device drivers that are
loaded on the PC before starting the CNC.
407