System information

APPENDIX
453 Tool pot not up during turret movement
Check to see if the POT UP switch is functioning as it should be.
454 Not at tool change position
Try commanding a G32 before the M6 command.
455 ATC arm is not out, axis movement not allowed
456 Can't process auto tool change after switching to manual
457 Move length too great for control (split into smaller moves)
458 X axis is in the manual mode. Push reset to enable it
459 Y axis is in the manual mode. Push reset to enable it
460 Feedrate too large for control.
500 Last softkey pressed is not supported at this time
501 Illegal address "#" encountered
The character within quotes " " is not a valid address, such as X, Y, Z, R, G, etc.
The block where the error occurred is shown in the block display. Check that
block for the invalid address.
502 Undefined canned cycle
503 Return without gosub
Refer to page 328, Section 5 about gosub and return.
504 Coincident points, the start point and end point are the same on an arc without
a center
The start point and end point are the same on an arc without a center.
505 Radius too small to span given points
Start and end points are more than "R" distance apart.
507 After compensation, line to arc lacks intersection
509 After compensation, arcs lack intersection
515 Unexpected file size
The control read a file that was not the correct size.
412