System information

APPENDIX
517 Parameter out of range
Parameter number is less than zero. For parameter numbers greater than 699 you
must use data mode (G10, G11).
518 Illegal program statement
Command in program statement is not considered valid.
519 Feedrate out of range
The programmed feedrate is beyond the "maximum feedrate" parameter value in
the machine setup parameters. The program feedrate may be negative.
520 Spindle speed out of range
The programmed spindle speed is beyond the "spindle range" parameter in the
machine setup parameters. The programmed spindle speed may be negative.
521 Negative arc radius
An attempt was made to generate a negative arc radius.
522 Negative polar radius
A polar radius must be specified as a positive value.
523 Illegal tool number
Valid T numbers are 0 - 99.
524 Illegal radius number
Valid D numbers are 0 - 99.
525 Illegal length number
Valid H numbers are 0 - 99.
526 Invalid access code
The access code does not match that which is loaded in the machine setup
parameters.
527 Invalid access level
Valid levels are 0 - 4.
529 Duplicate address' encountered
The same address was found twice on the same block, such as X0 Y0 X.5.
530 Colinear line to line in round corner
531 Colinear line to arc in round corner
532 Colinear arc to line in round corner
413