System information

APPENDIX
533 Colinear arc to arc in round corner
535 Chamfer length is < 0
Chamfer length must be a positive number.
536 Can't chamfer and round the same corner
Choose either chamfer or round corner.
537 Can't chamfer to or from arcs
538 Loop counter out of range
The maximum number of loops for a call is 999.
539 Dwell time out of range
Probably a negative number was specified. The maximum dwell time is
999999999 seconds.
540 Illegal dwell time "#" encountered
Try G4 F##.####; specify X, P, or F after G4.
541 No axis moves are allowed on a G31 or G32 block
G31 and G32 are intended to move Z only. Relocate X and Y moves to another
block.
542 G30 Illegal return to reference parameter on G30 block
The number of digits used is beyond what the address is expecting. For example,
G100 should only be two digits.
Should be P2, P3, or P4 for second, third, and fourth reference point.
543 Illegal G10 statement
544 Too many digits in number
545 Illegal K value for number of holes
K must be a number between 1 and 1000.
546 Nested calls or gosubs too deep
Probably a program is calling itself. Nest limit is 50 for program calls.
547 Comment not closed
Always use "( )" (parentheses) in pairs for program comments.
549 Unrecognized G code
G code encountered is not recognized by the control.
414