System information

APPENDIX
072 Spindle on in Dry Run
073 Tool Table Diameters\Radius
076 Load Canned Cycles
075 Load Engraving Cycles
077 Check Spindle up to Speed
078 Check Spindle Zero Speed
079 G18 is ZX or XZ plane
080 Cad Type DXF or CDL
081 Special Flags
082 Offset Round and Tapered Walls
083 Full Dos File Names
085 Primary Serial Port
086 COM1 Baud Rate;
087 COM1 Data/Stop Bits and Parity
088 COM2 Baud Rate;
089 COM2 Data/Stop Bits and Parity
090 Tape Start Character
091 Tape Stop Character
092 RS-232 Buffer Size
093 Secondary Serial Port
094 RS-232_End of file character
096 Power up with Block Skip On
097 Power up with Optional Stop On
099 Display Multiple Block Lines
100-109 Post M-code Table
110-119 Custom G-code Table
120-129 Custom M-code Table
130-145 M6 Macro File Name
146 Drive on Menus
160-175 Report File Name
190 Check Air Pressure
192 Run in 2 or 3 Axes mode
193 Boot to 2 or 3 Axis mode
194 Old Front Panel System
195 Way Lube Timer
196 Update Skill Level
197 Hand Wheel
198 Skill Level
199 Manual Option
200 ATC Clockwise Coast
201 ATC Clockwise Brake
202 ATC Counter Clockwise Coast
203 ATC Counter Clockwise Brake
204 Electronic Spindle Gears
206 Show current position in E-Stop
209 Spindle Dac Value
420