System information

APPENDIX
542 Yaskawa M5 drive
543 Machine State 0=Nothing 1=Verifying 2=Program Running
544 Check Spindle in Gear
P195 Scale factor opt. axis
P198 Angle of rotation
P200 Previous position (X)
P202 Previous position (Z)
P206 Previous pos. opt. axis
Real Parameters
Great care must be taken when writing to any parameters other than the User Parameters
P00-P99.
P174 Mirror position axis 3 (Z)
P00- User Parameters
P175 Mirror position axis 4 (A)
P99
P176 Mirror position axis 5 (B)
P177 Mirror pos. optional axis
P100- Probe Parameters
P178 Mirror pos. optional axis
P111
P179 Mirror pos. optional axis
P180 Scale position axis 1 (X)
P112- Unassigned
P181 Scale position axis 2 (Y)
P139
P182 Scale position axis 3 (Z)
P183 Scale posiiton axis 4 (A)
P140 R plane
P184 Scale position axis 5 (B)
P141 Final Z depth
P185 Scale position opt. axis
P142 Z initial level
P186 Scale position opt. axis
P143 Z increment
P187 Scale position opt.axis
P144 First Z depth
P188 Scale factor axis 1 (X)
P145 Z feedrate
P189 Scale factor axis 2 (Y)
P146 Peck up increment
P190 Scale factor axis 3 (Z)
P147 Peck clearance
P191 Scale factor axis 4 (A)
P148 Dwell 1
P192 Scale factor axis 5 (B)
P149 Dwell 2
P193 Scale factor opt. axis
P150 Pocket radius
P194 Scale factor opt. axis
P151 X pocket dimension
P152 Y pocket dimension
P196 Rotate I position
P153 XY finish stock
P197 Rotate J position
P154 Z finish stock
P155 Cut width
P199 Auto Routines Plunge / Ramp
P156 Bolthole radius
P157 Bolthole start angle
P201 Previous position (Y)
P158 # holes in 360 degrees
P159 # holes to be made in Bolthole
P203 Previous position (A)
P204 Previous position (B)
P160- Unassigned
P205 Previous pos. opt. axis
P170
P207 Previous pos. opt. axis
P171 Holes to be made in drill cycles
"K"
P208 Current position (X)
P209 Current position (Y)
P172 Mirror position axis 1 (X)
P210 Current position (Z)
P173 Mirror position axis 2 (Y)
422