System information

SECTION TWO - FRONT PANEL OPERATION
20 English 21 Metric
22 Safe zone check off 23 Safe zone check on
24 Circ Pocket Clear 25 Circ Finish Inside
26 Circ Finish Outside 28 Reference Return
29 Return From Ref 30 2nd-4th Ref Return
31 Z to Clearance 32 Z to Tool Change
33 Facing Cycle 34 Rect Pocket Clear
35 Rect Finish Inside 36 Rect Finish Outside
39 Threading Cycle 40 CutterComp Off
41 Left CutterComp On 42 Right CutterComp On
43 + H Offset Dir 44 - H Offset Dir
45 Left Auto Comp On 46 Right Auto Comp On
47 Auto Comp Off 49 Cancel Tool Offsets
50 Scaling Off 51 Scaling On
52 Local Coordinate 53 Machine Coordinates
54 Worksystem 1 55 Worksystem 2
56 Worksystem 3 57 Worksystem 4
58 Worksystem 5 59 Worksystem 6
60 One-Shot Rapid Move 61 Exact Stop Mode
63 Tapping Mode On 64 Tapping Mode Off
65 Move Lockout Block 68 Rotation On
69 Rotation Off 70 Mirror Image Off
71 Mirror Image On 72 Bolt hole
73 Woodpecker Drill 74 Left Tap
76 Fine Bore 78 Manual Bore
80 Canned Cycle Cancel 81 Drill
82 Drill/Dwell 83 Peck/Drill
84 Tap 85 Bore
86 Fast Bore 87 Back Bore
88 Hard Tap (option) 89 Bore/Dwell
90 Absolute 91 Incremental
92 Set Floating Zero 93 Inverse Time Feed
94 Inches per Minute 95 Inches per Revolution
98 Ret to Initial Level 99 Return to R-plane
Note: The text file that displays the legal G codes on the screen is Gcodes.XXX, where XXX is the
extension for the corresponding language. The control first looks for Gcodes.XXX in the RAM
directory. If not found, it then searches the ROM directory for the file.
F2 (Mcode) Main-MDI-Mcode
F2 (Mcode) will bring up a list of legal M codes with a short description of each code.
00 Program Stop 01 Optional Stop
02 End of Program 03 Spindle On CW
04 Spindle On CCW 05 Spindle Off
06 Tool Change 07 Mist On
33