System information

SECTION TWO - FRONT PANEL OPERATION
Put Pot down on Yes means the pot will be down for the pending tool.
swing arm tool changers: No means it will be up.
Check drawbar switch: Yes for newer machines with drawbar switches.
Milltronics ATC is: Plunger, Geneva Two-Step, Geneva One-Step or Swing Arm
Milltronics CW Coast: Partner 1 Geneva tool changers use these
Milltronics CW Brake: Parameters to set the times to index and
Milltronics CCW Coast: brake the tool changer in the CW and CCW
Milltronics CCW Brake: directions. Suggested values are 110 for coast and 60 for brake.
Check Air Pressure: If the parameter is set to yes and the pressure is low (Y input #1),
the machine will emergency stop and error 448 “Air Pressure
Error. Check air hose connection” will occur.
Drawbar Delay: Used in the Partner tool changers as a delay (in seconds) after the
drawbar comes on and before the head goes up to remove the tool
to prevent pulling on the tool holder.
Custom M and G code Tables
Custom G code O9010
Custom G code O9011
Custom G code O9012
Custom G code O9013
Custom G code O9014
Custom G code O9015
Custom G code O9016 Cannot have a custom G code for G0
Custom G code O9017
Custom G code O9018
Custom G code O9019
Custom M code O9020
Custom M code O9021
Custom M code O9022
Custom M code O9023
Custom M code O9024
Custom M code O9025
Custom M code O9026 Cannot have a custom M code for M0
Custom M code O9027
Custom M code O9028
Custom M code O9029
41