System information

SECTION TWO - FRONT PANEL OPERATION
Parameter file version: Should always be 1
Use Small Soft keys: Should be set to no for 12" CRT monitors
Notes on Parameters
Note 1: To change a parameter, press F1 (Edit) and type in the new number.
Note 2: After changing any power parameter, return to the main menu before cycling power.
Note 3: After any power parameter is changed, the machine must be powered down, then up
again. These parameters are only read on power up.
F4 (Axis) Main-Parms-Setup-Axis
If the F4 (Axis) key is pressed, the following screen will be displayed.
Keys displayed when F1 (Edit) is pressed:
The PgUp, PgDn, and arrow keys move through the tables on the upper display. The lower
display changes to show the data associated with the cursor position of the upper display. To edit
the values in these tables the cursor is positioned using the arrow keys to the desired parameter in
the upper screen. When the F1 (Edit) key is pressed the cursor will move to the lower screen.
Next, move the cursor using the arrow keys to the axis or parameter desired and type in the new
values using the keypad. After the new values have been entered, press the ESC (Esc) key. The
new value will be entered and the cursor will return to the upper screen; the selection process
42