System information

SECTION TWO - FRONT PANEL OPERATION

Home Sequence These numbers determine

X 02.0000 the order the axes will home in:

Y 02.0000 #1 first, #2 next, etc. Axes with

Z 01.0000 the same number home together. 0 will

cause that axis to not home.

Positive Limit Dimension from machine zero where

X 00.0000 the positive software limit occurs

Y 00.0000

Z 00.0000

Negative Limit Dimension from machine zero where

X -31.0000 the negative software limit occurs

Y -18.0000

Z - 6.5000

Maximum Feed Sets the maximum G01 feedrate in

X 200.0000 inches per minute or mm per minute

Y 200.0000

Z 200.0000

Dry Run Feed Sets the dry run feedrate in inches

X 75.0000 per minute or mm per minute

Y 75.0000

Z 75.0000

Rapid Velocity Set the maximum G00 feedrate in

X 800.0000 inches per minute or mm per minute

Y 800.0000

Z 800.0000

Feed S-Curve Acc The units are identical to the (linear) acc/dec. These ramps

(Cent 7 and up) are used when the s-curves are enabled in feed moves.

Rapid S-Curve Acc The units are identical to the (linear) rapid acc/dec. These

(Cent 7 and up) ramps are used when the s-curves are enabled in rapid

moves.

Acc/Dec The Acc/Dec is a number that determines the rate at

X 20.0000 which the axis velocity is increased or decreased for

Y 20.0000 feed moves. The smaller the number the longer the

Z 20.0000 Acc/Dec times will be. Acceleration and deceleration in

this control are linear ramps. Units are in inches per sec².