System information

SECTION TWO - FRONT PANEL OPERATION

Rapid Acc/Dec The Rapid Acc/Dec is a number that determines the

X 20.0000 rate at which the axis velocity is increased or

Y 20.0000 decreased for rapid moves. The smaller the number

Z 20.0000 the longer the Acc/Dec times will be. Acceleration and

deceleration in this control are linear ramp units and are in

inches per sec².

Feed S-Curve Acc The units are identical to the (linear) acc/dec. These ramps

(Cent 7 and up) are used when the s-curves are enabled in feed moves.

Rapid S-Curve Acc The units are identical to the (linear) rapid acc/dec. These

(Cent 7 and up) ramps are used when the s-curves are enabled in rapid

moves.

Slow Jog Velocity

X 50.0000 Velocity in IPM or MMPM

Y 50.0000

Z 50.0000

Fast Jog Velocity

X 200.0000 Velocity in IPM or MMPM

Y 200.0000

Z 200.0000

Jog Key Direction Sets whether the Jog is related to moving the table or

X 00.0000 moving the tool. A “1" reverses the direction

Y 00.0000

Z 00.0000

In Position After any rapid move, the machine will wait until all

X 00.0050 axes are within position to the destination before

Y 00.0050 starting the next block

Z 00.0050

G00 Unidirectional Sets the distance in inches or mm which an axis will

X 00.0000 go past the destination point in one direction before

Y 00.0000 reversing direction so that the machine will always

Z 00.0000 position from the same direction. Active only in G00 mode.

Uni-distance