System information

SECTION TWO - FRONT PANEL OPERATION

G60 Unidirectional Same as G00 unidirectional except only active in a

X 00.0000 G60 block

Y 00.0000

Z 00.0000

Backlash Sets the distance in inches or mm. The control will

X 00.0000 compensate for lost motion whenever an axis

Y 00.0000 reversal takes place. Active in all modes.

Z 00.0000

Excess Error Sets the distance in inches or mm. The machine can

X 00.2500 lag behind the CNC. The CNC will shut the system

Y 00.2500 down due to an excess following error.

Z 00.2500 00.0000 = will never force an excess error.

Rotary=0 Linear=1 Sets whether an axis should be treated as rotary or

X 01.0000 linear. In rotary, the feedrate is interpreted as

Y 01.0000 degrees per minute rather than inches per minute.

Z 01.0000 There is no conversion between inch and metric for rotary

axis.

Handwheel Normal=0 Invert=1 A “1" will reverse the direction of the handwheel.

X +00.0000

Y +00.0000

Z +00.0000

English Leading Sets the number of characters to the left of the

X 02.0000 decimal point for the inch system, for the specified

Y 02.0000 axis only

Z 02.0000

English Trailing Sets the number of characters to the right of the

X 04.0000 decimal point for the inch system, for the specified

Y 04.0000 axis only

Z 04.0000

Metric Leading Same as English Leading except for the metric case

X 03.0000

Y 03.0000

Z 03.0000

Metric Trailing Same as English Trailing except for the metric case

X 03.0000

Y 03.0000

Z 03.0000