System information

SECTION TWO - FRONT PANEL OPERATION
Use FLZ instead of G54 Used for setting work offset in jog and handwheel mode. Yes
means use FLZ (G92 offsets). No means use G54 offsets.
Tool Setting If set to any tool the jog and handwheel tool setting routines will
prompt the operator for the tool # being set. If it is set to current
tool the control will assume the active tool # is the one that is being
set.
Tool Setting Use If set to No, the position given by the operator is relative to home.
Work Offsets If set to Yes, the position given is relative to the work offset (this is
useful for tool setting off the table and using a Z work offset to the
top of the part).
Extract Input Programs If set to Yes, the control will extract programs based on 0###'s in
file loaded from the floppy drive or received in RS-232. Duplicate
programs are overwritten without prompting the operator.
P899 Consult factory for special options.
Resolve DNC programs If Yes, goto's can be used in DNC, Run, or DNC Verf.
Full Dos File Names If Yes, eleven character DOS file names [FILENAME.EXT] may
be used. Pressing the “D” key on any menu toggles the Full Dos
File Names parameter.
Disable 417 Errors If Yes, parameters may be modified while a program is running or
verifying. If No, an error 417 will be given when attempting to
modify a parameter while a program is running.
Load Tool Offsets Set to Yes each time a program is started or when entering MDI.
The tool offsets will default to the values from the tool table for the
current tool. If set to No, the tool length and radius will default to
zero.
Multiple Block Display If Yes, the current block being executed plus the next seven blocks
will be displayed when programs are running.
CAD Parameters
CAD Type is, DXF, CDL CAD file type to import in conversational programming.
CAD Epsilon Tolerance for geometry intersections of imported CAD files.
54