System information

SECTION TWO - FRONT PANEL OPERATION

If the door is open and Setup is held in, the machine will handwheel up to the 70% rate on the

feedrate override switch, which is 2mm per click of the handwheel. (It is difficult to generate

speeds greater than 1000 mmpm in this mode). Modifying the distance per click of the

handwheel also requires a password available only to the machine builder.

If the doors are opened while the machine is running:

1 The spindle will shut off.

2 The axis will stop moving.

3 The feed-hold light will come on.

4 The spindle will not restart.

If Setup is pressed, the machine will move at the clamped feedrate while the button is held in.

To continue operation:

1 Close the doors (the Cycle Start Button will flash).

2 Push the CW button on the front panel (the spindle will restart).

3 Push the Cycle Start Button on the front panel (the Cycle Start Button will stop

flashing and the feedhold light will go out).

F4 (FdOvr) Main-Parms-Setup-OVRs-FdOvr

The F4 (FdOvr) key brings up the feedrate override parameter settings. These settings determine

which percentage will be used for each of the 16 feedrate override switch positions. (Entry 5-040

means 40% at 5th position, 1 is 0%, 2 is 10%, 3 is 20% . . . 16 is 0%.) The following screen is

displayed when F4 (FdOvr) is selected. To edit the parameters, select F1 (Edit) and move the

cursor to the value to be changed. Type in the desired change and press Enter.