System information

SECTION TWO - FRONT PANEL OPERATION

F2 (Coord) Main-Parms-Coord

The F2 (Coord) key of the parameter screen brings up the parameters dealing with the various

coordinate systems in the control. To edit the work coordinate parameters, use the PgUp, PgDn,

and arrow keys to position the cursor to the correct parameter, then push the F1 (Edit) key and

arrow to the desired axis. Type in the new values and press Enter, then ESC (Exit). The

following screen shows the G92, G52, and Work System parameters G92/G52/54-59 described

in the G code section. The next page of this display contains parameters for the following.

Positive Safe Zone A position relative to machine zero which, along

X 00.0000 with the negative safe zone position, describes a

Y 00.0000 cube that the tool cannot enter. If the tool is programmed

Z 00.0000 into this cube an error will be displayed.

Negative Safe Zone G22 turns the safe zone off

X 00.0000 G23 turns the safe zone on

Y 00.0000

Z 00.0000

G28 Reference Point 1 Are described in Section 4, page 222.

G30 Reference Point 2

G30 Reference Point 3

G30 Reference Point 4

Notice G54 through G59 work coordinates have subsets. To view/edit, for example, G573 work

offset, move cursor to the work coordinate 4 (G57), then toggle (F3) until the subset reads 3.