System information

SECTION TWO - FRONT PANEL OPERATION
F5 (H Off) Main-Parms-H Off
The F5 (H Off) key displays the 99 H tool length offsets available on the control. These offsets
are accessed and edited in the same manner as all other parameters. The H offset screen follows.
The cursor will default to the active tool number.
F6 (Save) Main-Parms-Save
F6 (Save) saves all files in the RAM directory to a floppy. You will be informed that duplicate
files on the floppy will be overwritten. You will then be asked to verify by pressing F1 (Ok).
F7 (Load) Main-Parms-Load
Loads files from a floppy disk into the RAM directory. You will be informed that the current
parameters will be overwritten. You will then be asked to verify by pressing F1 (Ok).
64