System information

SECTION TWO - FRONT PANEL OPERATION

P304 Status if control is in data mode or normal programming

(o=off, 1=on)

P305 H offset direction or sign

P306 Status of 0=G0, 1=G1, 2=G2, 3=G3 mode

P307 Not used

P308 Number of active plane 0=G17 (X4), 1=G18 (ZX), 2=G19

(YZ), 3=G18 (XZ)

P309 Cutter comp. status 0=G40, 1=G41, 2=G42, 5=G45,

6=G46

P310 Current active canned cycle number: 0=Canceled, 1=Drill,

2=Drill /Dwl, 3=Peck I, 4=Tap, 5=Bore, 6=Bore II, 7=Peck

II, 8=Hard Tap, 9=Bore/Dwl, 10=Left Tap, 11=Cir Pck

Clear, 12=Cir Fin Inside, 13=Cir Fin Outside, 14=Rec Pck

Clear, 15=Rec Fin Inside, 16=Rec Fin Outside, 17=

Threading,18=XZ sweep, 19=YZ sweep

P311 0 = Absolute, 1= Incremental mode

P312 Feed unit (0 is feed/min, 1 is feed/rev, 2 is inverse

feed)

P313 Spindle unit (0 is RPM, 1 is constant surface speed)

P314 CW or CCW spindle direction

P315 0 = Inches, 1 = Metric dimensions

P316 Scaling (0 = off, 1 = on)

P317 Rotation (0 = off, 1 = on)

P318 Mirror image (0 = off, 1 = on)

P319 Current work coordinate number (G54=1, G55=2…G59=6)