System information

SECTION TWO - FRONT PANEL OPERATION

P320 thru P322 Gives the primary, secondary, and tertiary axis based on

plane selection

X=1 Y=2 Z=3 . . . etc

For G17 XY pri=1 sec=2 ter=3

For G18 ZX pri=3 sec=1 ter=2

For G19 YZ pri=2 sec=3 ter=1

For G18 XZ pri=1 sec=3 ter=2

P323 0 = Return to R-plane (G99), 1 = initial level (G98)

P324 Tapping mode (0 = off, 1 = on)

P369 Job time (sum of run times)

P370 True tool number used for tool changers

Block Rate Block per second for the last program executed.

F9 (CTRL) Main-Parms-CTRL

This set of parameters is an extension of the F8 (Prog) parameters. This group deals primarily

with parameters used to create the auto-routine and canned cycles. These parameters can be

accessed and changed in the same fashion as all other parameters in the control. The following is

a list and description of these parameters.

Load Text Cycles Yes to load the text engraving cycles. If it is set to No and

a text command is executed, an error 578 “Undefined text

cycle” will occur.

Offset Round Tapered See description of M95 and M96 (pages 308 and 312 in

Walls Section 5).

Spindle Range Which gear range the spindle is in

Chip Remove On (Min) If the machine is equipped with a chip auger removal

system, this specifies the time that the auger will run after

an M38 or after pushing the front panel Auger button.

Wash Down On (Sec) While the auger is running, the wash down cycles on

Wash Down Off (Sec) and off using these times.

Sort Directories by Name If yes, it sorts the menus alphabetical by the 1

line of the

program.

Drive Key on Menus If yes, the help key allows the operator to select a new

drive for the menu.