System information

SECTION TWO - FRONT PANEL OPERATION

P150 Circular auto-routines radius, rectangular auto-routine,

corner radius

P151 X rectangular pocket dimension

P152 Y rectangular pocket dimension

P153 XY finish stock for autoroutines

P154 Z finish stock for autoroutines

P155 Cut width on pocket clearing autoroutines

P156 Radius of bolt hole cycles

P157 Bolt hole start angle

P158 Bolt hole number of holes in 360°

P159 Bolt hole number of holes to be drilled

P160 thru P171 Scratch

P172 thru P179 Coordinates of the center position for a mirror image

command for the enabled axis

P172=X P173=Y P174=Z . . . etc

P180 thru P187 Coordinates of the scaling center for the enabled axis

P180=X P181=Y P182=Z . . . etc

P188 thru P195 Scale factor for each of the enabled axis

P188=X P189=Y P190=Z . . . etc

P196 I, J, K position of primary axis center of rotation

P197 I, J, K position of secondary axis center of rotation

P198 Angle of rotation

P199 Auto routines plunge/ramp Z axis

0 = plunge, 1 = ramp

P346 Used by G76 (fine bore) and G87 (back bore) cycles

Bore Relief Angle when oriented and moving away from the bore

P347 Same as P346

Bore Relief Distance