System information

SECTION TWO - FRONT PANEL OPERATION
F3 (Words) Main-Prog-Text-Edit-Words
The F3 (Words) soft key represents reserved words that may be used for programming the
control.
Pressing a key will cause that word to be printed on the screen. See Section 6 on parametric
programming.
Note: F6 (RETRN) will print RETURN.
F4 (Misc) Main-Prog-Text-Edit-Misc
This section discusses a number of commands that do not readily fit into any of the other
category.
F1 (UnDo) Restores whole lines deleted with the delete line command or the delete
block command. It does not restore single characters or words.
F2 (Rest) Will undo any changes made to a line of text as long as you have not left
the line. The line is restored to its previous contents regardless of the
changes made.
F3 (HDW) Allows the use of the handwheel to move to a position. You may insert the
axis position in the program by pressing the Enter key.
F1 - F4 (X/Y/Z/A) Choice of axis position to insert
F6 (LnDel) Deletes the line containing the cursor and moves any lines below it up one
line. The cursor moves to column 1 of the next line.
F7 (Chang) This operation works the same as the Find command except that you can
replace the found string with any other string of up to 67 characters. After
entering the search string, you are asked to enter the replacement string.
The last replacement string entered, if any, will be displayed; you may
accept it, edit it, or enter a new string. Finally, you are prompted for
options. The options you used last are displayed first. You may enter new
options (canceling the old ones), edit the current options, or select them by
pressing Enter. The options available are the same as those for the Find
command.
79