System information

SECTION TWO - FRONT PANEL OPERATION
F8 (Find) Lets you search for a string of up to 67 characters. When you enter this
command you will be asked for a search string. The last search string
entered, if any, will be displayed. You can select the string again by
pressing Enter, or you may edit it or enter a new search string. After the
search string is entered you must specify your search options. The options
you used last, if any, are displayed. You can enter new options (canceling
the old ones), edit the current options, or select them again by pressing
Enter. The following options are available.
B Searches backwards from the current cursor position toward the
beginning of the program.
G Searches globally. The entire program is scanned for the search
string regardless of the current position of the cursor. The search
starts at the beginning of the program if searching forwards and at
the end if searching backwards.
L Limits searches to the currently marked block.
U Ignores case; treats all alphabetic characters as if they were
uppercase.
W Searches for whole words only; skips matching patterns embedded
in other words.
If the text contains a target matching the search string, the cursor is
positioned just beyond it.
Note: An additional option is available for the change operation.
N: Without the "N" option, before changing each string, a prompt
"Replace Y/N/A/Q" will allow the operator to
Y: Yes - change it
N: No - don't change it
A: REPLACE ALL without prompting
(used with "G" global option)
Q: QUIT - stop (used with "G" global option)
ESC: does the same thing as quit
80