Instruction manual

Page 10 XPS/XCT Transducers– INSTRUCTION MANUAL 7ML19981AK01
Dos and Don’ts
Installation shall only be performed by qualified personnel and in accordance with
local governing regulations.
Do not route cable openly.
For optimum isolation against electrical noise, run cable separately in a grounded metal
conduit.
Seal all thread connections to prevent ingress of moisture.
Do not run cable near high voltage or current runs, contactors and SCR control drives.
Note: For pressure tight applications, install transducers hand tight plus ½ turn
to 1½ turns. Teflon®tape or other appropriate sealant may be used to aid in
sealing the threads for use in pressure applications.
WARNING: Never attempt to loosen, remove, or disassemble process
connection while vessel contents are under pressure.