Instruction manual

7ML19981AK01 XPS/XCT Transducers– INSTRUCTION MANUAL Page 3
These devices should only be supplied from a circuit containing a suitably rated fuse that
has a breaking capacity of 4000A. This fuse is included in Siemens Milltronics
transceivers.
Repair of the equipment shall be carried out in accordance with the applicable code of
practice and Installation Instructions.
The certification of this equipment relies on the following materials used in their
construction:
Manual override can be accomplished by using the disconnect switch provided in the
building installation of the associated controller.
XPS D Series Product Marking
Enclosure
Kynar® complete with carbon nanotube (Polyvinylidene Flouride
(PVDF) with carbon nanotube [RTP Part No. 3399 X 93208 E]).
Encapsulant Stycast LA-9823-76 or Durapot® 864 (as appropriate)
Note: Kynar® polyvinylidene flouride is resistant to attack from most chemicals
under the described operating conditions. However, for exposure to specific
environments, check with chemical compatibility charts before installing the
XPS/XCT Transducers in your application.
WARNING: This product is designated as a Pressure Accessory per
Directive 97/23/EC and is not
intended for use as a safety device.
SERIAL No.:
V 1.77 V r.m.s.; 250 V
I 44.2 mA r.m.s.
AMBIENT TEMP.: –40 C TO 95 C
IN
IN
: p
:
.
XPS-xxD ULTRASONIC TRANSDUCER
0518
SIEMENS MILLTRONICS PROCESS INSTRUMENTS INC. PETERBOROUGH
SEE INSTRUCTION MANUAL FOR OPERATION.
PETERBOROUGH, CANADA
SIRA 01ATEX5262X