Assembly Instructions

Stand the Table up, with assistance from your adult partner.
Exert pressure floorwards, onto the Table with both your hands.
This pressure will help the Legs and Table Top reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly
secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and excute the same above process.
If the Table is not Stable it could lead to damage to the product.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Place the Table Top(A) facedown onto a clean, non-marring surface.
Attach Leg(B) into the mounting position at the corner of the Table Top(A) using Bolts(①),
Washers(②), and Spring Washers(③) with Allen Key(④) as shown above.
Repeat the same process with the remaining three Legs(B).
Do not fully tighten the Bolts.
Step 2
Step 3
4 of 5