Instruction Manual

Instruction Manual

Please save this manual for future reference.

BEFORE USING THIS APPLIANCE:

1. Please check the circuit break for this appliance on?

2. Light bulbs may become loose during shipping, if the flame effect is dim or does not operate properly at first, ensure that

the light bulbs are properly secured in the sockets (bulbs should be finger tight, don’t over tighter) see “Replacing Light

Bulb” section of this manual for instructions.

3. The information regarding this appliance can be found on the rating plate located on the back of the unit

PLUGGING IN THE HEATER:

1. Make sure the appliance main “I/O” is switch OFF (refer to operating instruction section)

2. Plug the unit into a no less 15Amp/120V outlet.

OPERATING INSTRUCTIONS

NOTE:

1. When you first turn the heater on, it may emit a slight but harmless odor. This odor results from certain oils or greases

being heated as the appliance is used for the first time. This odor is perfectly safe and will stop shortly, it will not reoccur

after the first operation of the appliance.

Control Panel

Using the Control Panel:

Master Power Switch(A)

Open the cover and push button A down (1) to “on” position. (see FIG A)