Instruction Manual

Instruction Manual

Please save this manual for future reference.

FLAME EFFECT

Push “ON/OFF” (On/Off) button (B) or “ON/OFF” (On/Off) button (M) on the remote control to begin flame effect. The red

power light “ ” and dimmer light “ ” will automatically come on. The flame effect can be adjusted by pressing the dimmer

“ ” button (C) or dimmer “ ” button (L) on the remote control. When pressed, the red light will blink and the flame effect

will cycle from high to low. Press the dimmer “ “ button (C) or dimmer “ “ button (L) on the remote control again to lock

in desired flame brightness. The red light “ “ will remain on. This brightness will be kept until the dimmer “ ” button (C)

or dimmer “ ” button (L) on the remote control is pressed again.

HEAT SETTING

1. Turning on Master Power Switch (A) and “ON/OFF” (On/Off) button (B) or “ON/OFF” button (M) on the remote control

2. Press “LOW” button (D) or “LOW” button (K) on the remote control to active the low heater setting. The red light above

will indicate that the heater is functioning on low.

3. Press “LOW” button (D) or “LOW” button (K) on the remote control again to shut off the heater.

4. Press “HIGH” button (E) or “HIGH” button (J) on the remote control to active the high heater setting. The red lights

above “LOW” and “HIGH” buttons will indicate that the heater is functioning on high.

5. Press “HIGH” button (E) or “HIGH” button (J) on the remote control again to shut off the heater.

Note

When the heater begins to work, it will give off cool air for about 10 seconds before the heating function is activated

Using the Remote Control

This heater includes a remote control. To operate the appliance using the remote control, the Master Power Switch (A)

must be the “ON” position. See below for directions to use the remote control: