Owner's Manual

ManualsBrandsMillwood Pines ManualsFurnitureBob 20.5'' W Electric Logs

Table Of Contents

PLEASE SAVE THESE INSTRUCTIONS

Electrical Fireplace Stove with Heater

OWNER’S MANUAL

PLEASE SAVE THESE INSTRUCTIONS

WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE.

Thank you for choosing our Electric Fireplace. This owner’s manual will provide you with valuable

information necessary for the proper care and maintenance of your new product. Please take a few

moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of

your new heater.

When using this electric unit, basic safety precautions should always be followed to reduce the risk of

fire, electric shock, and injury to persons, including the following:

IMPORTANT INSTRUCTIONS

Summary of content (9 pages)

PAGE 1
Electrical Fireplace Stove with Heater OWNER’S MANUAL PLEASE SAVE THESE INSTRUCTIONS WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE. Thank you for choosing our Electric Fireplace. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new heater.
PAGE 2
1. 2. 3. 4. Read ALL instructions before using this unit. CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater yourself. This heater may get hot when in use. To avoid burns, DO NOT let bare skin touch hot surfaces. Keep combustible materials, such as furniture, pillows, bedding, paper, clothes, and curtains at least 3 ft from the front of the heater and keep them away from the sides, top, and rear. DO NOT place towels or other objects on the heater. 5.
PAGE 3
SPECIFICATIONS Voltage Rating 120 V (60Hz) Power Consumption 1500W Unit Size 20.5 in. (W) x 8.7 in. (D) x 7.9 in. (H) Unit Weight 5.5KG SAFETY FEATURES Overheat Safety Feature This heater is equipped with a overheat safety feature. When the heater’s internal components reach a certain temperature that could cause overheat or possible fire, the heater will automatically shut off.
PAGE 4
PRODUCT DIAGRAM Artificial charcoal set Control panel Air outlet Power switch Receiver cover Control Panel 4
PAGE 5
Timer light: Indicate the timer mode Timer button: User setting timing boot or shutdown Heater button: Set up the heat mode and turn off the heat. Flame button: Set the brightness of the flame Power button: Powers the heater on and off.
PAGE 6
Power button: Powers the heater on and off. Timer button: User setting timing boot or shutdown. Heater button: Set up the heater mode and turn off the heat. Flame button: Turn on/off the flame and adjust the brightness. PREPARATION Place the heater on a firm, level surface and plug into a 120V 60Hz power outlet. Caution: The rear of the heater should be at least 4 inch away from the wall. Please pull the insulating film out of battery cover before using the remote control.
PAGE 7
Press the Power button on the remote control, the heat and flame effect will be on. Press the Power button again, heat and flame effect will be off immediately (but the fan will prolong working for 30 seconds), and then the heater goes into a standby mode. 2.Setting timer-power-off Caution! ONLY under power-on mode can you set timer-power-off function. When the unit is power on, press the Timer button to set timerpower-off function (through control panel or remote control).
PAGE 8
The corresponding light is on when timer –power-on is set. 3.Setting heat Under standby mode, press Heater button to start heater. Under standby mode, press the Heater button on the control panel or remote control, the heater will start (The heater indicator is under the artificial charcoal set. When heat is on, the charcoal set will be lit up and flicker automatically at a slow pace). Press the Heater button again.
PAGE 9
7. If won’t use the unit for a long time, please take out battery in remote control according to following steps, then take care of the remote control. STORAGE Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the original packaging to repack the unit. TROUBLE SHOOTING If the heater will not operate, please check the following before seeking repair advice: 1. Check if the power cord is plugged into an electrical outlet, if not, plug in. 2.