Operating instructions

Safety—Rigid Washer Extractors

PELLERIN MILNOR CORPORATION

1.1. Laundr

Facilit

—Provide a supporting floor that is strong and rigid enough to support–with

a reasonable safety factor and without undue or objectionable deflection–the weight of the fully

loaded machine and the forces transmitted by it during operation. Provide sufficient clearance fo

machine movement. Provide any safety guards, fences, restraints, devices, and verbal and/or

posted restrictions necessary to prevent personnel, machines, or other moving machinery from

accessing the machine or its path. Provide adequate ventilation to carry away heat and vapors.

Ensure service connections to installed machines meet local and national safety standards,

especially regarding the electrical disconnect (see the National Electric Code). Prominently post

safety information, including signs showing the source of electrical disconnect.

1.2. Personnel—Inform personnel about hazard avoidance and the importance of care and

common sense. Provide personnel with the safety and operating instructions that apply to them.

Verify that personnel use proper safety and operating procedures. Verify that personnel

understand and abide by the warnings on the machine and precautions in the instruction manuals.

1.3. Safety Devices—Ensure that no one eliminates or disables any safety device on the machine

or in the facility. Do not allow machine to be used with any missing guard, cover, panel or door.

Service any failing or malfunctioning device before operating the machine.

1.4. Hazard Information—Important information on hazards is provided on the machine safety

placards, in the Safety Guide, and throughout the other machine manuals. Placards must be kept

clean so that the information is not obscured. They must be replaced immediately if lost or

damaged. The Safety Guide and other machine manuals must be available at all times to

the appropriate personnel. See the machine service manual for safety placard part numbers.

Contact the Milnor Parts department for replacement placards or manuals.

1.5. Maintenance—Ensure the machine is inspected and serviced in accordance with the norms of

good practice and with the preventive maintenance schedule. Replace belts, pulleys, brake

shoes/disks, clutch plates/tires, rollers, seals, alignment guides, etc. before they are severely

worn. Immediately investigate any evidence of impending failure and make needed repairs (e.g.,

cylinder, shell, or frame cracks; drive components such as motors, gear boxes, bearings, etc.,

whining, grinding, smoking, or becoming abnormally hot; bending or cracking of cylinder, shell,

frame, etc.; leaking seals, hoses, valves, etc.) Do not permit service or maintenance by

unqualified personnel.

2. Safety Alert Messages—Internal Electrical and Mechanical

Hazards

[Document BIUUUS11]

The following are instructions about hazards inside the machine and in electrical enclosures.

WARNING 1 : Electrocution and Electrical Burn Hazards—Contact with electric powe

can kill or seriously injure you. Electric power is present inside the cabinetry unless the main

machine power disconnect is off.

• Do not unlock or open electric box doors.

• Do not remove guards, covers, or panels.

• Do not reach into the machine housing or frame.

• Keep yourself and others off of machine.

• Know the location of the main machine disconnect and use it in an emergency to remove

all electric power from the machine.