Installation manual

Chapter 2. Programming
PELLERIN MILNOR CORPORATION
Display or Action Explanation
4
Stop with drain—The basket is kept stationary while draining to
prevent abrasion from mechanical action. During the fill phase o
f
this step, basket motion is controlled by the Type of step decision.
This selection is not valid if the next step is an extract. If a bath is
programmed with this option, then an extract is programmed
immediately following the bath step, the controller will change
the drain code from 4=Stop with drain to 0=Standard drain
speed.
5
Stop with fill and drain—The basket is held stationary during
both the fill and drain phases of this step. Basket rotation, as
determined by the Type of step decision, begins only after the
desired level is achieved. This selection is not valid if the next step
is an extract. If a bath is programmed with this option, then an
extract is programmed immediately following the bath step, the
controller will change the drain code from 5=Stop with fill and
drain to 3=Stop with fill.
03 SPD DRE
01 x
If the machine is equipped and configured for a second drain,
select the drain destination for this step.
0
Drain to sewer
1
Drain to reuse
03 TMMQFFFHC LSCWSS*
02 x
The cursor returns to this display to program the next step unless
the step just programmed is the last step of a formula or if the
number of steps exceeds 50, in which case the cursor advances to
decision E.
END FORMULA #03
0 NO
Appears if T=0 in previous display and this is not the last
available step in this formula.
0
No. Aborts the previous T=0 selection. Display returns to the T
(type of step) decision.
1
Yes. Accepts that the formula ends here.
03 SPD D E
02 x
Determine how this formula should end.