Installation manual

Chapter 4. Troubleshooting
PELLERIN MILNOR CORPORATION
Table 14: E-P Plus Outputs
Output
Number
Page-Colu
mn
Description
Device Consequences of Actuation
1
0-a Inject chemical 5 K1 Operates inject device for chemical 5
2
0-b Inject chemical 1 K2 Operates inject device for chemical 1
3
0-c Inject chemical 4 K3 Operates inject device for chemical 4
4
0-d Inject chemical 3 K4 Operates inject device for chemical 3
5
0-e Inject chemical 2 K5 Operates inject device for chemical 2
6
0-f Hot water valve K6 Opens valve
7
0-g Cold water valve K7 Opens valve
8
0-h Drain solenoid K8 Closes drain
9
0-i Flush valve K9 Opens flush valve
10
0-j Cooldown (if equipped) K10 Operates cooldown valve, if equipped
11
0-k Extra water (if equipped) K11 Operates extra water valve, if equipped
12
1-a Reuse drain (if equipped) K12 Operates reuse drain, if equipped
13
1-b Steam (if equipped) K13 Operates steam valve, if equipped
14
1-c Inject chemical 6 K14 Operates inject device for chemical 6
15
1-d not used K15
16
1-e Door interlock K16 Energizes door latch to locked position
17
1-f Unlock door K17 Energizes door latch to unlocked position
18
1-g Wash clutch K18 Engages wash clutch
19
1-h
Extract speed (use only with
empty cylinder)
K19
Locks door, releases brake (if any), and turns
cylinder at extract speed.
20
1-i
Distribution (drain) speed
(Door must be closed)
K20
Locks door, releases brake (if any), and turns
cylinder at drain speed.
21
1-j
Clockwise wash speed (Door
must be closed)
K21
Locks door, releases brake (if any), and turns
cylinder clockwise at wash speed.
22
1-k
Counter-clockwise wash speed
(Door must be closed)
K22
Locks door, releases brake (if any), and turns
cylinder counter-clockwise at wash speed.
23
Buzz signal
Board-mounte
d signal
Sounds operator alarm
24
Run light
Board-mounte
d light
Turns on light in Start button (
\)
25
Reversing wash speed Functional test Locks door and reverses cylinder at wash speed.
26
High extract speed Functional test
Locks door and turns cylinder clockwise at wash
speed, then high extract speed.
27
Fill to level 1 Functional test
Locks door, closes drain, fills to level 1 with cold
water.
28
Fill to level 2 Functional test
Locks door, closes drain, fills to level 2 with cold
water.
4.1.5. Testing and Verifying the DIP Switch Settings
For all E-P Plus models, the set of default formulas is determined by how the DIP switches on the
processor board are set. The bank of DIP switches is identified in Figure 7.