- Pellerin Milnor Corp. Computer Hardware User Manual

ManualsBrandsMilnor ManualsComputer HardwareKXMIC00155

Published Manual Number/ECN: H000000013/99462N

• Publishing System: TPAS

• Access date: 1/18/01

• Document ECN's: Latest Available

Kit Instruction—

KXMIC00155

PELLERIN MILNOR CORPORATION POST OFFICE BOX 400, KENNER, LOUISIANA 70063-0400, U.S.A.

Summary of content (4 pages)

PAGE 1
Published Manual Number/ECN: H000000013/99462N • Publishing System: TPAS • Access date: 1/18/01 • Document ECN's: Latest Available Kit Instruction— KXMIC00155 PELLERIN MILNOR CORPORATION POST OFFICE BOX 400, KENNER, LOUISIANA 70063-0400, U.S.A.
PAGE 2
Please Read About the Manual Identifying Information on the Cover The front cover displays pertinent identifying information for this manual. Most important, are the published manual number (part number) /ECN (date code). Generally, when a replacement manual is furnished, it will have the same published manual number, but the latest available ECN. This provides the user with the latest information applicable to his machine.
PAGE 3
HXMIC00155 INSTRUCTIONS FOR KIT KXMIC00155 1) Save the current memory in a data storage device. 2) Remove the video card from the video interface board. 3) Remove the processor, memory board and ribbon cable from the machine. 4) Remove the EPROMS from the old processor and memory board. 5) Install the EPROMS in the new processor board according to the tag. 6) Mount the video card bracket on the processor board using the metal screws.
PAGE 4
2 KEYPAD DISPLAY INPUTS 1MTA39 1MTA38 1MTA36 1MTA37 1MTA40 1MTA35 J1 EPROMS SEE NOTE EPROMS MUST BE INSTALLED WITH NOTCH IN POSITION SHOWN. IC64 IC63 IC30 IC29 BPB PROCESSOR BOARD W1 EDGE CARD CONNECTOR BBVI INTERFACE BOARD PELLERIN MILNOR CORPORATION B2TAG95001 95027G MICRO 6 SYSTEMS 8088 PROCESSOR WITH CGA INTERFACE NOTES: 1.EPROMS MUST BE INSTALLED IN THE CORRECT SOCKET FOR THE MACHINE TO OPERATE. THE TOTAL NUMBER OF EPROMS MAY VARY. EACH EPROM IS NUMBERED 1,2,ETC a.