User`s manual

MPS Doc: UPS_AS_UM Rev (-) May 23, 2012 Page 13 of 38
2. Deleting (or modifying) the Application configuration file:
{CommonApplicationData }\Milpower Source\Ups Auto Shutdown\
MpsUpsServiceConfig.xml will delete the password. Restarting the
computer or the MPS UPS Service, after deleting the Configuration file, will
enable the reconfiguration of all the Application’s settings (including the
resetting of the password).
3. The Configuration Password is local to each PC station. A different Password
may be used on each PC station and setting or changing a Password on one
PC station will not affect the Password on any other station.
3.2.2. To change or set the Configuration Password click the "Change" button and
the following screen will appear:
3.2.3. Enter the Current Password. If Password was not set yet, leave this field
empty.
3.2.4. Enter the new password in the "New Password" field and repeat it in the
"Confirm New Password" field. To remove the password, leave both fields
empty.
3.2.5. Click "OK" to confirm the change.
3.3. Setting the UPS Communication Parameters
The following describes the settings of the Communication parameters of the
Application. These parameters must have identical values as those of the UPS that
the Application will communicate with.
In the Configuration window (see Paragraph 3.1.2) set the following parameters:
3.3.1. "UPS IP Address" - (the default UPS IP address is 192.168.0.19).
3.3.2. "SNMPv3 Security" – set the SNMPv3 security level (the default is the
highest available security setting: "MD5 Authentication, DES Privacy").