User`s manual

MPS Doc: UPS_AS_UM Rev (-) May 23, 2012 Page 22 of 38
5. Configuration Examples
5.1. Monitor Only Mode
It is possible to configure the Application to monitor the status of the UPS without
taking any action (i.e. without shutting down Windows or the UPS). This mode of
operation may be useful when there is a need to remotely monitor the status of the
UPS.
5.1.1. To configure the Application to this mode open the Configuration window.
5.1.2. Configure the "UPS Communication" parameters as described in
Paragraph 3.3 – “Setting the UPS Communication Parameters”.
5.1.3. Set "Low Charge Warning Threshold" and "Low Charge Shutdown
Threshold" as desired. Note that in Monitor only Mode, the "Low Charge
Shutdown Threshold" will only warn the user about the battery status but
will not cause an actual shutdown:
5.1.4. Uncheck the followings:
 Run Custom Shutdown Program.
 Shutdown Windows.
 Shutdown UPS.
 Perform Shutdown when communication with UPS is lost.
 Perform Shutdown when UPS Over Temp.
5.1.5. Select "Start Shutdown Procedure" under "When detecting UPS Shutdown
command from another PC".