User's Manual

7
Chapter 3
Installation Instructions
3.1 General
The Receiver/Repeater 2A should be installed by a professional technician.
3.2 Installation
For on-site installation of the Receiver/Repeater 2A device, proceed as follows:
1) Loosen the four screws fastening the unit's panel and open the box end cover.
2) Connect the 12 volt DC power supply (use only U/L approved power supply) to
the 5-pin connector
3) Close case
4) Install screws and mount to wall or to mast
5) Connect the Coax cables at both ends – to the repeater/receiver and to the antenna